Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2014 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

p/s pump replacement 850 1997

I have a p/s pump I need to replace and the junk yard unit I have included the pulley but not the reservoir. Has anyone replaced the reservoir on these ? I am just curious before I take the unit off and attempt the r/r of the fluid reservoir. there has been mention of a special tool to r/r the pulley and reservior but no specific mention of the reservoir by itself. Also are there any o-rings/seals that need to be replaced during this procedure ?








  REPLY TO THIS MESSAGE    PRINT   SAVE 

p/s pump replacement 850 1997

I have done a couple but it has been a while. As I recall there are two clips that retain the reservoir, remove them and the res should slide right off. There is a rubber seal underneath it that seals the whole thing. It does require a special tool to R&R the pulley but I do not think it is necessary to change out the reservoir.

Good Luck,
Mark








  REPLY TO THIS MESSAGE    PRINT   SAVE 

p/s pump replacement 850 1997

Thanks !!!







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.