Volvo AWD V70-XC70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2002 V70-XC70 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Installing IPD TME Exhaust V70-XC70

I have a 1998 V70T5 and just purchased a TME exhaust system from IPD. I need some hints on installing it. I don't want to take it to a muffler shop unless I have to.

How hard will it be to remove the stock exhaust? I'll have to cut it and remove it in two pieces, right? After that it seems installing the new TME exhaust will be straightforward. Any things I should watch out for? Help from someone who has already done this will be greatly appreciated. Thanks.








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Installing IPD TME Exhaust V70-XC70

The only problem you will have is getting the car off the ground far enough to get the new exhaust in. When I replaced the pipe on a 1995 850T, I had the jack stands holding up the rear as far as the stands extended and I still needed an additional inch. That was close to 24 inches.
When mating the new exhaust to the cat, it helps to have a helper push the new exhaust into the old one while the clamp (you will need a new one, and bolts) is being tightened.

Klaus
--
Please answer your responses. We need to know if the advice is good or bad. The 164 has a new home, all I am left with are 2 turbos :)







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.