I am replacing both drive axles. Done with the right axle, but I can't remove the driver's side. I've got the axle nut off and the end out of the steering knuckle, I just can't pull or pry the dam thing out of the gearbox! Right axle came out no problem, though I see that there is a small clip at the end of the left axle (the replacement part) that is not at the end of the right axle. I am assuming that this clip is not neccesary on the right side becuase it has a carrier bearing. I've used a large scewdriver as Hayne's suggests to pry between the gearbox and the axle to no avail. Also tried a larger pry bar. Perhaps a slide hammer is neccesary? Thanks.