Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2005 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

going to try ipd 2B1850 - Polyurethane Upper Engine Stabilizer Mount 850 1995

I replaced my saggy right lower motor mount - mostly cause this torque arm bushing looked like it was sliding off towards the center. Now time to replace that crumbling torque arm bushing - once done by the dealer as part #9434263. Normally I wouldn't stray from volvo parts - but i didn't see anything in volvospeed's repair section on pressing out the bushing so I think I'll try the IPD part. Good idea?








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    going to try ipd 2B1850 - Polyurethane Upper Engine Stabilizer Mount 850 1995

    I did it on my 1998, never had a problem since. Some folks claim more engine vibration is felt, but I never noticed it.

    Klaus
    --
    1967 220 belonging to C.A. lives on








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    going to try ipd 2B1850 - Polyurethane Upper Engine Stabilizer Mount 850 1995

    I have used them and they do well. Seem pretty much a permanent cure for me.

    dick







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.