Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2007 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: Replacement of PNP switch on Trans 850 1995

posted by  someone claiming to be M. Hirsh on  Mon Mar 26 07:33 CST 2001 [RELATED]

Is the alignment tool mentioned in the bay 13 procedure absolutely needed to replace this switch? Has anyone done it without this tool? The dealers seem to sell the switch, but not the tool. Also is this a lengthy or complicated job?

Thanks for any feedback







  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Re: Replacement of PNP switch on Trans 850 1995

    posted by  someone claiming to be John O on  Mon Mar 26 16:55 CST 2001 [RELATED]

    You can do it without the tool but it may not be as accurate. Tighten the switch where it seems centered and make sure it starts the car in P&N only, reverse lights work in R.

    It's not a bad job, just follow the instructions there.






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.