Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2013 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Gorillas and rust 850

posted by  KlausC on  Sat Jun 6 12:36 CST 2020
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

I really hate rust, but combine that with a gorilla mechanic, I am ready for a hand grenade!

Simple job: replace rotors and pads in the front. No big deal. Until the caliper brackets do not budge. I have an electric impact gun and a 15mm 6 point socket. I even have a 5/8 pry bar. The impact gun is too large to fit in the wheel well. A 16oz hammer on the pry bar doesn't do anything. PB Blaster doesn't do much. I even tried a little heat (careful of the axle boot and bump stop on the control arm).

Am I forced to crawl to the local garage with my tail between my legs? They will probably use a small grip air pressure impact gun and have it off in 2 minutes.

Of course, my luck would have the rotor frozen to the hub!!!

The mechanic suggested replacing the control arms last year. I suppose I could have him install a pair of Lemforders, and let him do me a favor of loosening the 15mm bolts???

--
Keeping it running is better than buying new






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Gorillas and rust [850]
posted by  KlausC subscriber  on Sat Jun 6 12:36 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.