Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2018 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

upper cylinder head 850 1996

posted by  Jippi on  Mon Aug 8 23:10 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Feb 22 04:25 CST 2007
[RELATED]

how do you install the upper head/valve cover to the lower head? torque specs? i am almost done rebuilding the engine, i used a hold down tool to compress it but there is a small gap between the 2 sections, i dun wanna tighten it too much because the bolts are so small i am afraid they might snap.
thanks in advance jippi








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

upper cylinder head 850 1996

posted by  Rule 308 on  Tue Aug 9 09:55 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 8 09:20 CST 2012
[RELATED]

From the inside out to 17nm or 12.53854 ft. lbs.

Mark







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.