Greetings. I'm in the middle of removing the left half shaft from my 850. I read through many ofthe previous postings and unlike others I had little problem removing the axle nut or freeing the axle from the wheel. I then used a crowbar and was able to free the inner end of the axle from the trans. My pleasure with how easily the job seemed to be proceeding came a crashing halt at this point, as the axle only came about 3 cm out of the trans. before catching and refusing to come further. I have tried prying on it further with a block of wood between the prybar and the trans., but without luck. Any ideas or suggestions?
|