Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2004 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Gasket needed or just o-ring where oil cooler meets pan? 850

posted by  rocketman4321 on  Mon Jul 7 09:41 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jul 6 10:32 CST 2014
[RELATED]

I replaced the rectangular o-ring where my oil cooler return/thermostat (?) meet the oil pan. I'm sure things are seated, but it still leaks like crazy. (At least I think it's this leaking--decent puddle in 15 sec.) Screws are down nice and firmly. Lines are clamped all the way in. Should I have added the sealant like I used on the pan-to-block?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Gasket needed or just o-ring where oil cooler meets pan? [850]
posted by  rocketman4321  on Mon Jul 7 09:41 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.