Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2000 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Control Arms, Ball Joints 850 1995

posted by  Erwin on  Sun May 6 12:54 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 10:39 CST 2014
[RELATED]

I need to replace the control arms on my '95 845T. On the last trip I took, at 80mph there was a bad shimmy in the steering wheel. Before tracking that down I noticed that turning into the parking lot at work, where there is a sharp cut in the concrete ramp, I'd hear a metallic rattle. Sounded like loose pads.

I just got out from under the car and the pads and end links are fine, but I can wiggle the driver's side hub about 1/4" against a sloppy ball joint.

I have another 1400 mile trip ahead, leaving Wednesday, so question is; if I get new control arms locally, how long to put two in? Looks like it could be easy. Is an air wrench needed? Otherwise I'm at the mercy of having it done in a garage and I have never been satisfied with other's work. I've always had to go back or re-do the job myself.

Should I go with OEM Volvo or is there a reliable aftermarket brand?

Thanks,

Erwin

'95 845T 180,000 miles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Control Arms, Ball Joints [850][1995]
posted by  Erwin  on Sun May 6 12:54 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.