Volvo AWD V70-XC70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2010 V70-XC70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Propeller Shaft Removal V70-XC70 2003

posted by  LarryU on  Fri Nov 30 11:07 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jan 16 19:25 CST 2013
[RELATED]

OK. I am at the end of my rope here!!! I am trying to remove my AWD bevel gear to Haldex differential Propeller shaft without success. I have the front coupler disengaged, the carriage bearing unmounted and free, I have the rear coupler to the Haldex unit all unbolted and I can not for the life of me pull out the C.V. joint out of the Haldex flange. I have tapped on the outside of the coupler, I have tried to install an 8mm SHCS into the back of the coupler to try to "push" out the C.V. joint from the coupler and also tried using a punch thru the extra holes in the back of the coupler (not the six holes where the SHCS's hold everything together-the other holes). I am at the point of removing the rear differential at this point!!! Any advice is greatly appreciated...






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Propeller Shaft Removal [V70-XC70][2003]
posted by  LarryU  on Fri Nov 30 11:07 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.