Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2004 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

ECC vent motors 850

posted by  KlausC on  Sun Sep 1 11:56 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

What a job! At least 3 of my ECC vent motors are messed up. I cleaned one of them - floor/defrost - of dried grease and also fixed the plastic connector part of the flapper.

QUESTION:

How does one position the damper motor and damper flaps? I will have to run the program to allow the ECC unit to 'learn' the position of the newly refreshed motors, but I have no idea how the motor and the damper are supposed to line up. Damper closed, open, or in the middle. Same for the motor.

Any advice is good. Because these things are so hard to get off and back on, I would like to only do it once more!!!

Thanks,

BTW, this is also posted on Matthewsvolvo site.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ECC vent motors [850]
posted by  KlausC subscriber  on Sun Sep 1 11:56 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.