Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2005 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: Peeling paint on 850 roof drip molding 850 1995

posted by  someone claiming to be Leon Tong on  Mon Sep 14 16:45 CST 1998 [RELATED]

Just so Scott doesn't end up having to fax the instructions to all of us, here's an excerpt from the factory service manual "Interior/Exterior":

Replacing roof trim

-------------------

Remove rear end piece:

1. Heat with a hot air gun and slide backward.

2. Carefully pry up trim as illustrated. (The illustrustion shows the use of a small spatula to lift the trim off the body)

3. Start from the back. Use a wooden spatula or similar.

Install:

1. rear trim end piece.

2. Trim with end piece on roof. NOTE! Start by pressing the trim into place at guide clip 4. (clip 4 is the one on the roof nearest the windshield)

3. Press the trim into top clip 5 on the A-post so that it is positioned correctly between the roof ad windshield. (This is the top-most clip on the A-pillar).

4. Press down the trim backwards along the roof and downwards onto the A-post.

5. Install the end piece on the roof.

------- end of instructions ------

Leon

'86 244 149K

'96 855 29K






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.