Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

DIY brake job successful - BUT caliper boot has a little gap

posted by  someone claiming to be a beginner on  Mon Apr 22 04:17 CST 2002 [RELATED]

After only 20K I couldn't stand the warped rotor, and PBR pads grinding when hot so I put new rotors and Volvo pads on. The job appears to be a success. However, inspection of the caliper indicated that there is a little gap about 3/4 inch long where the bottom edge of the dust boot pulled out. I couldn't get it to tuck back in. I tried pushing on it but couldn't get the lip back past the piston. I didn't want to push too hard and poke a hole or rip it. Is there a method to get it back in without pulling the entire caliper? I just left it. Should I worry about just leaving it?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New DIY brake job successful - BUT caliper boot has a little gap
posted by  someone claiming to be a beginner  on Mon Apr 22 04:17 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.