Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2002 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

front engine mount 850

posted by  Phantom on  Thu Jun 26 12:14 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Sep 5 18:49 CST 2014
[RELATED]

Things always sound easier than they turn out to be. It has been a while since I did this, but to the best of my recollection I removed the two 14mm bolts, then raised the engine up as far allowable. I used either a 1/2" ratchet or breaker bar. I think that on one or both of the bolts I needed to use a swivel or a short extension. The real key was adding an 18" inch piece of pipe that I keep around for this purpose to my wrench. This gives me about a two foot long handle to pull on. If you are using a swivel, make sure that it is braced up against something.

Phantom






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New front engine mount [850]
posted by  Phantom  on Thu Jun 26 12:14 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.