Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2009 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Thermostat replacment 850 1997

posted by  vwstuart on  Mon Dec 8 14:31 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I just replaced the thermostat in our '97, 850. I had such a hard time removing the rear bolt. The torx bolt just stripped out, and I would up removing the fuel injectors to get just enough room to get a tiny vice grip on the bolt. After many, many failed attempts at removal, I was able to get it out. I replaced the thermostat, and replaced the top part. I put the good bolt in the rear, and then ground a slot on the bad bolt to fit a flat screwdriver. I got it all back together and it works like a champ.

What should I do about the bad bolt. I got it in tight, and there are no leaks. Should I just leave it, and deal with it the next time I replace the thermostat? Should I replace it with a hex hed bolt? What thread size is it, and what is it made of (is it aluminum, steel or what)

Any advice is welcome.

thanks,
Stuart






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Thermostat replacment [850][1997]
posted by  vwstuart  on Mon Dec 8 14:31 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.