Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2012 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

I replaced upper torque bushing 850 1996

posted by  JimH on  Fri Apr 9 16:09 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Just wtd to share my experience. I had to cut the old one out & was able to press the new one in without even removing the bracket. I used an approximately 12" piece of 3/8" threaded rod, 2 nuts, & 4 washers, & (2) 1" galvanized / black pipe flanges. I put the new bushing in the freezer, then put some oil on it & cranked the nuts down.

whole job took about 1/2 hour. $10 in parts. You can do it.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I replaced upper torque bushing [850][1996]
posted by  JimH subscriber  on Fri Apr 9 16:09 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.