Art,
Thank you so much for all of your help during this fiasco. I did pull fuse#6 at some point during my trouble shooting, so it has already been out of the holder.
I am getting ready to order a bentley manual, but so far I am not sure how to check codes on the 240's. What should I do at this point? Remove the fuse again? It was removed before I replaced the pump. It is barely noticeable, but it is a little rough in drive, at a stop (it has an auto trans.)
Thanks everyone for all of your help!! Next, strut inserts and urethane CA bushings. Then, I will have it pretty much done for now.
|