Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2022 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

simple question about proper jacking 200

uid 12839's pic
posted by  Paul Driver of Inga on  Sun Nov 29 14:11 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 25 16:42 CST 2012
[RELATED]

I have two 2 1/2 Ton jacks and two sets of jack stands and also have the heavy duty rubber chocks for the wheels.

I have had my car up on the "Red Neck Rack" before but decided to hold off putting the front of the car on jack stands for the rear bushing change out. Started out by getting the front tires firmly chocked and then raised the entire rear by jacking up on the pumpkin. Put jack stands under the rear jack points and that car was not going anywhere once all that was done.

Depending just how far in you have to go, you may just need the other set of jack stands under the rear axle. I had the axle of my 86 held in the air by the other set of jack stands when the poly bushings were being pressed in.

This is one of those jobs that air tools make so much faster if you have access to them.

Good Luck,

Paul





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New simple question about proper jacking [200]
posted by  geodonuts  on Sun Nov 29 13:02 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.