Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

use the scissor jack but use it for... 200

posted by  transit wind on  Sun Nov 29 19:24 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 15 22:40 CST 2014
[RELATED]

positioning the sway bar bolts/holes to the trailing arm. I had to use my jack to inch it up into place. I did each sides on different days. Make sure you have something to keep the two thin pieces of metal that the TAB slide into from bending together. That piece of pipe cut to be inserted there. If you don't have one for some reason I've used the little round metal tube that helps to hold the lower shock bolt in place. It should slide right in between the two and make for removal and replacement much easier.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New simple question about proper jacking [200]
posted by  geodonuts  on Sun Nov 29 13:02 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.