Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ignition Key Stuck in Position 3 200 1981

posted by  machine man on  Sat Apr 20 09:25 CST 2024
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 15:40 CST 2014
[RELATED]

Hi,

Oh boy, you sure got some bumps on your pickle this morning. 🥴

I don’t know about having to pull the whole steering column at this point but I will bet the lock cylinder is pinned on one side somewhere around the perimeter of the aluminum casting.
That pin holds the entire lock cylinder. It will look like a dimple in the casting.

Maybe they have made in such a way as to make it hard to drill out. IE located between the space area towards the dashboard.
This would be a handy time for a small right angle drill attachment.

I’m trying to think of what has jammed the tumblers inside the slot so badly.
Have you tried lots of silicone spray to flush out any bits or shavings of worn tumblers?

Phil






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ignition Key Stuck in Position 3 [200][1981]
posted by  81242DLB21FCA  on Sat Apr 20 00:35 CST 2024 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.