Error: you cannot edit this post. It has been too long since it was posted.

Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hitch for my 940 900

posted by  spook on  Sun Jun 30 14:22 CST 2024
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 08:06 CST 2014
[RELATED]

Dear Metallo,

Hope you're well. I'd get a two-inch bike-holder and have the end - that supports the bike holder(s) - welded to the 1.25" Volvo piece, that goes into the Volvo hitch's receiver.

Unless the three e-Bikes are hugely heavy, that arrangement - if done by a competent welder - should suffice.

This is likely to take less time - and cost less - than trying to source a bike-holder, with a 1.25" specification.

Hope this helps.

Yours faithfully,

Spook






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hitch for my 940 [900]
posted by  Metallo  on Sun Feb 25 12:19 CST 2024 >
  • New NMI [900]
    posted by  Dave Stevens  on Sun Feb 25 15:27 CST 2024 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.