Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2017 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

differential 200 1984

I am rebuilbing my differential in a 84 turbo 240 wagon.
Gears are 3.73's sSandard dana 30 prbuild parts match except the ring and pinion. Has any one installed atandrad dana gears with sucess ???

I hate to think of the price for ring and pinion from Volvo !

Thanks, John L








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Torsen time 200 1984

If you're going to use non-Volvo parts, go all-out and install a Torsen or LSD setup meant for a Jeep (I think some Cherokees used a Dana 30 as well).


-b.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Torsen time 200 1984

The new parts I have are early model jeep dana 30 stuff. Patrick @ ext:5562 @ "Randys ring and pinion" @ www.ringpinion.com was 90% sure it was a match.I just did not want to waist time in the set up if there was a long term issue. This car is strong and driven hard. The volvo ring and pinion have larger contact areas (about 25% larger) than stock dana. If it sets up ok than NO PROBLEMS...

Thanks for the input !!

John







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.