Hi again gents,
I have a cod problem; (90 740 turbo) the car will run good for a while and out of the blue will get a check engine light. When I pull the fault code I seem to only get the 2-3-2 code and then when I try to clear it the memory will not clear unless I disconnect the battery for a few seconds and reconnect it. In the past with other codes I was able to clear them on the diagnostic module. This code has been repeating about 5 times at about 150 mile intervals???? Anybody have any suggestions on what to do. I was going to change the O2 sensor but hate to spend the $$$ if I’m wrong
thanks MO
|