Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 seat springs popping off in the corner 200 1989

posted by  greg_mustang on  Tue Apr 18 03:47 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 10 07:26 CST 2014
[RELATED]

Hi All,

Continuing the saga of the seat repair (while the dash is being re-assembled; while waiting for some new floor foam), I completed it, fixed the lumbar support (new steel wire) and put together the bottom spring assembly.

Wow it's comfortable! But after sitting on it twice the two springs at the end of the bottom spring square (at the side of the seat pivot) popped off again.

To be honest, I do not understand how these are supposed to stay in place, the end of the steel rods are 'bent' outwards at about 45 degrees, is this supposed to keep the springs from sliding off? It doesn't with my 200 lbs.

Has anyone found any solid solution for "capping" the ends of the steel rods in the spring assembly?

Thanks, I hope I was descriptive.

Greg
Montreal, Canada





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 seat springs popping off in the corner [200][1989]
posted by  greg_mustang  on Tue Apr 18 03:47 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.