Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2009 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

ignition switch 200 1993

I have to replace my ignition switch on my 93 240 and can't figure out how to get the old one out. Can anyone guide me thru this?








  REPLY TO THIS MESSAGE    PRINT   SAVE 

ignition switch 200 1993

The switch electrical part is held to the back of the key/lock cylinder with 2 screws. The connections to it are just a big plug with pins and sockets.

You might be able to reach up behind the knee bolster and kind of do this job blind. You will probably find it easier to remove the knee bolster screws and pull it out to get at the bottom of the dash that way.

On the older cars I've worked on, it's 2 slotted-head screws, not phillips or Torx. But Volvo is known for changing hardware, so you may find something different. A little mirror may help you see what you're doing up there and I recommend a good flashlight as well. It's simple, but of course access stinks.
--
Rob Bareiss, New London CT ::: 87 244DL- 249K, B230F/M47, Turbo sways, Bilsteins, GT braces, Virgos, Turbo exhaust, Gislaveds for winter!








  REPLY TO THIS MESSAGE    PRINT   SAVE 

ignition switch 200 1993

Since it is a 93 with no line of sight to the mounting screws, assume they are torx head, sorry, don't know what size.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.