Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2000 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 master cylinder nut size??? 200

posted by  bluePV544 on  Sat Jan 27 08:02 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Dec 15 19:44 CST 2013
[RELATED]

I am replacing a master cylinder on my 1991 240. I bought a set of flare wrenches for the brake lines. The 10mm is too small and the 12mm is too big. Does anyone recall if it is a 11mm? It sounds so simple however I have two sets of metric wrenches (flare & standard) and neither one came with a 11mm. Why not? My socket set has one. Thanks!
--
Bob Graham NC '65 544, '88 240 wagon, '91 240 sedan








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Sears Craftsman has an 11mm flare wrench 200

posted by  Jessie on  Sat Jan 27 13:26 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jan 18 17:45 CST 2011
[RELATED]








  REPLY TO THIS MESSAGE    PRINT   SAVE 

240 master cylinder nut size??? 200

uid 18083's pic
posted by  lucid on  Sat Jan 27 09:16 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:31 CST 2014
[RELATED]

All the brake line fittings are 11mm, but I used a 7/16" for years. The MC fittings should be easier to loosen anyway, being up where it's cleaner.

IMO, a 7/16" open end should work fine—unless they were over-tightened (flare fittings don't need a huge amount of torque to seal tightly).
--
Bruce Young
'93 940-NA (current), 240s (one V8), 140s, 122s, since '63.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

240 master cylinder nut size??? 200

posted by  mcduck on  Sat Jan 27 12:03 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 9 11:47 CST 2012
[RELATED]

And, a 7/16" flare wrench would be even better.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.