Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2013 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Outside Temp gauge installation Q 945 900

I just got an outside temp gauge from a 960 that I'd like to install on my 940. Does anybody know how to wire it? It has 6 wires going to it and I'd like to know which one goes where.
Thanks,

Csaba
'93 945T
'84 245Ti, sold








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Outside Temp gauge installation Q 945 900

    I have the installation instructions that I scanned in with Adobe, that I can email to you. But I would have to send it in several emails because the attachments are too large without a FTP site. The installation is very easy. As long as you can get the cluster out, you're almost home. The car is pre-wired in the harness.
    --
    I'm stuck on Volvo and Volvo's stuck on me....








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Outside Temp gauge installation Q 945 900

    hello
    not sure about the 960 setup.
    the 940 ambient temp guage fits in the bottom left of the cluster and is prewired for the guage, the wires are taped/hooked to the back of the cluster on the 940s and its plug and play.
    also the wires are up front driver side for the sender.
    good luck
    mike







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.