Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

metal lines in power steering gear(camgear) 200 1991

posted by  someone claiming to be truck11 on  Tue May 27 14:41 CST 2008 [RELATED]

GROTON SAYS I HAVE TO REPLACE THE WHOLE UNIT. THE VOLVO DEALER HAS THE LINES FOR $120.00. WHO'S RIGHT? ANYTHING I CAN USE BESIDES GOING TO VOLVO? THANK YOU.








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

metal lines in power steering gear(camgear) 200 1991

posted by  Herb Goltz on  Tue May 27 15:01 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 13:23 CST 2014
[RELATED]

The lines seem to be dealer-only items, I think, but you could have some built up at a hydraulic repair shop. When mine rusted out on my '92 945T (Koyo rack), I bit the bullet and bought them from the dealer. It was -15 deg and the fittings were really rusty, so I farmed the job out to a local indy.

If your rack has lots of miles on it, or the inner tie rods are less than perfect, a remanufactured rack is probably a better deal. Putting new lines on a rack with "morning sickness" or loose joints is false economy.

If money is tight, have a look around the local pick-and-pull-- you might find a good one cheap.

Good luck!







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.