Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2010 120-130 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Cross Member for M41 in Automatic Wagon 120-130

In order to free up space in my garage so I can proceed with shooting primer on my 544 project, I needed to hang the tail of the M41 I swapped into my BW35 wagon. The cross member for the M41 sits about 3 inches forward of the BW35 cross member. I have seen some photos using angle iron, but I can not seem to find them when I search. Is this the best solution?

I tried using angle iron today, but found the angle iron I had around the house was too flimsy to support the three inch extension and it interfered with the brake line / fuel line hold down clamp that is near the driver side mounting location. Also, I can not seem to find the mounting bolts in my box of labeled parts bags. Does anyone know what size bolt I need for the cross member?

Tyler








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Cross Member for M41 in Automatic Wagon 120-130

I believe all the bolts used on the crossmember are 3/8"-16 UNC, fairly short.
The mount itself has 7/16"-14 UNC threads. The bolts that mount the mount to the tranny are also 3/8"-16 UNC.
--
George Downs, Bartlesville, Heart of the USA!







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.