Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2007 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Bumper Cover Removal to Replace Fender 900 1994

posted by  Scottishbloke on  Sat Feb 26 10:15 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun May 13 03:25 CST 2012
[RELATED]

Trying to replace the driver's side fender on my '94 945t and can't see how to get the bumper cover loose to get at the last two bolts holding the fender on.

A quick answer would be greatly appreciated!

Thanks,

Matthew








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Bumper Cover Removal to Replace Fender 900 1994

posted by  tedv on  Sat Feb 26 17:06 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 18 10:51 CST 2014
[RELATED]

The cover is held on by four bolts/nuts (two on each side) right above the two openings covered by plastic caps visible from underneath. Take off the nuts and pull the cover straight out-it goes better with a helper, especially guiding it back on... Pretty easy unless the bolts are rusty.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.