Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2005 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Head Gasket Job Continued 900 1993

Thanks for all the tips, head gasket job proceeding well considering time limitations. Lifted head off today, verified what I knew, i.e. gasket was shot allowing coolant to leak out. Waiting for gasket kit from one of the usual suppliers (Elring kit) and have one question.

Can I simply put the new water pump seal (between pump and head) and drop the head on and get adequate squish of the seal or do I need to lower the pump and do it like I'm replacing a pump. Hopefully this makes sensel

Mike








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Head Gasket Job Continued 900 1993

Makes perfect sense. Just install a new seal in the pump groove, and bolt the head down. If it sealed before, it will seal now.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Head Gasket Job Continued 900 1993

Thanks for the tip. Mike








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Head Gasket Job Continued 900 1993

I did (yesterday) to my 1995 and it's holding up fine.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.