Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2007 120-130 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Head gasket - which side up? 120-130

I'm about to install the head after ring job. Top of gasket is not marked. No thickness dimension mark. There are a couple of numbers stamped into one side - "177 352" & "E2" & and Elring logo. I'm assuming this side goes up, but....

Based on Phil's rec, no copper coat - no nothing.

thanks








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Head gasket - which side up? 120-130

Logo Up. Does the gasket have a coating of any kind? I love Silverfrost for the head, sump & manifold gaskets.
--
Three 164's, Two 144's, One 142 & a partridge in a pear tree.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Head gasket - which side up? 120-130

standard stock Elring gasket. gasket material with a semi gloss finish.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Head gasket - which side up? 120-130

If there is a joining bridge showing between the two middle holes, that should be on one side only and is the top face. At least, that's the case with the one I've just looked at. It wasn't an Elring.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.