Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2004 200 INDEX

[<<] [>>]

THREADED

THREADED EXPANDED

FLAT

PRINT ALL

MESSAGES IN THIS THREAD

REPLY TO THIS MESSAGE

Replies to this message will be emailed.

SAVE

LH 2.2 AMM removing the plug 200 1988

posted by Propshaft on Fri Jul 12 03:19 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS]

[IGNORE ALL POSTS]

last visit: Fri Sep 6 14:30 CST 2013

[RELATED]

Hi, folks,

I would like to adjust CO on a B230F with LH 2.2.

At the AMM is a plug which can be removed. But I can´t......

There are still two holes drilled in the plug (previous workshop?), and I can rotate the plug.
But if I try to pull the plug with a plier it resists heavenly.

Any idea how to pull it out?
Have I to dremel around the black plastic tube?
Or can I threaden the plug and screw a bolt in to pull at? But if yes how deep?

Any pictures of the adjusting screw under the plug are welcome, if anyone has this.

cheers from Europe!

Michael

REPLY TO THIS MESSAGE

SAVE

LH 2.2 AMM removing the plug 200 1988

posted by Art Benstein on Fri Jul 12 04:52 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS]

[IGNORE ALL POSTS]

last visit: Fri Oct 17 20:10 CST 2014

[RELATED]

Go ahead and get rough. Yank it with a wood screw, or mangle it out with strong pick. The adjustment screw behind it is just a mechanical coupler with an o-ring seal leading to the potentiometer well behind it. In other words, the sensitive electronics are amply protected by the coupler between the tamper cover and the pot. Pretty sure I have a photo somewhere...

--
Art Benstein near Baltimore

Be careful of your tongue: It's kept in a wet place and could easily slip.

<< < > >>

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.