Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2002 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Power seat controls 700 1989

Most of the controls on the power seat have stopped working. I'd like to clean the contacts, but I don't want to break anything taking the control module out and taking it apart. How does it come out of the seat and how do you access the contacts once it is out?








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Power seat controls 700 1989

    On the left side under the switch is two bolts that hold the switch in. I find it easier to remove the seat bolts and tilt seat toward the back and disconnect the switch completely. Then proceed to a nice clean table top and carefully take it apart. I think you will find burnt switch contacts, clean with a fine grade of sandpaper and use silicone grease on the slides and contact points.








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Power seat controls 700 1989

      Thank you. That's all I needed to know.
      --
      The Breadbox - '89 745 GL, Elphie - '98 V70 AWD, Gloria - '93 244








      •   REPLY TO THIS MESSAGE    PRINT   SAVE 

        Power seat controls 700 1989

        I agree with Paulii, but emphasize that there are little parts in the switches, and a spring or two, that will go flying. And, some switches are so burnt they can't be repaired, so be ready to seek some at the JY. Pass side will have gotten less wear, usually.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.