Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2004 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Looking for a reliable OD intermediate housing gasket 200

Just replaced all of the gaskets from the intermediate housing back on my 85' M46.

They were almost paper thin and we almost added silicone, but decided against it.

Just hopped under the car and there is a decent drip where the intermediate housing and the
transmission meet.

I've checked IPD for a good green gasket, but can't seem to find what I need.

Any other recommendations?

Thanks








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Looking for a reliable OD intermediate housing gasket 200

    Did you replace the plastic crush seals under the top two nuts that hold the housings and brake ring together? That type of seal is a one use only.

    An alternative if you do not have the crush seals is a copper washer that fits the recess on the case drilled to the 5/16 bolt size. Or a Nylon washer fitting the recess with a steel washer over.

    I've torn a few of the thinner paper ones on install but never had them leak.

    Duane








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Looking for a reliable OD intermediate housing gasket 200

      We've taken apart the overdrive and intermediate housing and can't find any
      crush washers or any place a washer could go.

      Any pictures for reference? I might not be looking in the right place.

      thanks







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.