Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2020 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

No start when warm 900 1991

Turbo 940 won't start when warm. Fine when cold. Suspecting coil.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    No start when warm 900 1991

    I am struggling with a similer issue with my '90 740 GLE, but pretty sure it is the relay connectors.. primarily the radio suppression relay that controls the injectors.

    Check your connector body at the mentioned relay. Not sure where it is on your 940, but should be under the hood.

    First it might be good to read the faqs... better than I did. The things I have seen is the brass female connectors seem to lose tension, especially when the binding material within the connector body degenerates.. not holding the brass female connectors in place properly.

    I missed the part about resoldering the crimp where the wire connects to the female connector. That should be my next step, and then the JB Weld.

    I wish you well.

    --
    "Do you think that's air you're breathing now'? (The Matrix 1999) '94 940T (463K+), 92 245 (300K+), 90 740 (148k)







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.