Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2006 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

can pre 1989 cruise control stalk be wired to work on post 1990 200

I have a NOS 1989 cruise control stalk and wonder if the connector on it can be changed to work on a 1990 with cruise control. Looking at the wiring diagrams they appear to be different. If possible I would cut the connector off of a broke 1990 stalk and splice it to the 1989.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    can pre 1989 cruise control stalk be wired to work on post 1990 200

    Al,

    You can very easily disassemble your stalk, clean, and then re-assemble it to work like new. Note, I just disassembled the base, not the stalk per-say, but I was able to verify that everything in the stalk worked before putting it back together.

    I just did this on my 90' and all is now well in the world. While apart I placed dielectric grease on the internals and then put it back together.

    I used a two part epoxy to hold it together when I was done, and now for the life of me I can't remember the name.

    If you have questions, I'll try to guide you through.

    Matt







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.