Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2009 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Crankshaft Pulley (Harmonic Balancer - B230 Engine) - Proparts 900

Dear Fellow Brickboarders,

Hope you're well. I report that the Proparts Sweden Crankshaft Pulley / Harmonic Balancer (Volvo #9135194 / ProParts #21435194) - made in Korea - accepts the Volvo/IPD counter-hold tool. For no obvious reason, some "aftermarket" crank pulleys have slots too narrow to accept the counter-hold tool. The slots in the ProParts pulley are about 7mm in width (i.e., the narrow side of the slot)

The surface finish on the ProParts pulley is very smooth. Plainly, I do not know how this part will last: that depends critically on the durability of the rubber, between the steel core and the outer section, on which ride the drive belts.

Koreans' dedication to top-notch quality suggests this pulley will give many years service.

Hope this helps.

Yours faithfully,

Spook








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Crankshaft Pulley (Harmonic Balancer - B230 Engine) - Proparts 900

    Dear Spook,

    I've installed the same pulley from Proparts Sweden on Sept 2014. Until today no issues whatsoever. It also accepts my IPD crank holder nicely.

    Regards,
    Amarin.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.