Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2004 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

control arm main busings 900 1996

posted by  drzelmo on  Tue Nov 7 08:42 CST 2017
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 21 09:25 CST 2014
[RELATED]

Going to replace the main bushings in lower control but the replacement ones I got from Napa are metal instead of plastics -don't seem like they'll press in like plastic ones???? anyone had this issue with the difference in parts?
-- by the way got fuel pump issue fixed after replacing many components I should of checked for power at the pump first off.. had juice there all along the pump was dead..thanks for all the suggestions anyway..








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    control arm main busings 900 1996

    posted by  vp965 on  Tue Nov 7 16:12 CST 2017
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri May 2 15:40 CST 2014
    [RELATED]

    Should be plastic: do you mean the rear, larger diameter bushing (9191537)? The front ones are rubber inside metal casing: 6819537. Meyle bushings are just a few bucks at FCP Euro, can't be that bad for the rear. For the front, I'd be wary of putting aftermarket bushings in after having destroyed my control arms with a set of Febi's (they were just a tad bigger in the outer diameter...)
    --
    '98 965








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      control arm main busings 900 1996

      posted by  drzelmo on  Tue Jan 30 07:21 CST 2018
      Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
      last visit: Tue Oct 21 09:25 CST 2014
      [RELATED]

      yes the large ones .. at the rear of control arm.these are in 'professional parts sweden' boxes ? so i was not sure of the difference from plastic ones to the steel ones? don't seem like the steel will compress into the hole like the plastic ones?







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.