Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2021 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

aligning flexiplate for angular motion sensor 200 88

posted by  someone claiming to be mike on  Fri Apr 27 06:10 CST 2001 [RELATED]



Hi I,m in a bit of a bind I just sussed out that I need to align the flexiplate for the timing due to the ang mot sensor at a guess the two rivetted posts next to the solid part of the grilled piece on the flexiplate should be at the sensor at tdc. But the haynes manual just says mark the flywheel or drive plate, duhhh bit late now, can anyone pleaseeee heeelp

Mike







  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: aligning flexiplate for angular motion sensor 200 88

posted by  someone claiming to be Winston on  Fri Apr 27 08:49 CST 2001 [RELATED]

Mike, Turn the crankshaft so that #1cylinder is at TDC 2, position drive plate on the crankshaft so that pin (A) is approximately 15degree from the horizontal position and pointing away from the starter motor mounting. Note that there are two pins (A) & (B) Good luck.






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.