Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2009 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

My tale of woe! 700 1990

posted by  someone claiming to be Steve Wilson on  Thu May 31 05:16 CST 2001 [RELATED]

Hey, guys, I had a post the other day on milling my head, so this is a progress report- apparently this engine ( B230FT )had been overheated sometimes in it's life, and the head is warped. the machine shop ( a very good one ) is going to try to heat & straighten the head. no guarentees, it may crack.tho they have had success in the past. It had to be heated up to do a weld repair prior to milling anyway.Anyone have any experience with this process? assuming it fails; anyone have a head for sale? I was gonna do some preventitive maintenance on the turbo, while it was out; I'd noticed some oil smoke after prolonged Idle, but found the whole rotating group must be changed. appx $ 500.00. Compression on #1 & #2 cyls was 150 psi. this sound reasonable for 165K miles? how about rings & rod bearings while the car is down? can I pull the pistons/rods with the engine still in the mounts, ie from under the car? sorry for the long post. Thanks in Advance, Steve





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New My tale of woe! [700][1990]
posted by  someone claiming to be Steve Wilson  on Thu May 31 05:16 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.