Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2009 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

how do you get the damn oil pressure sender off of the block? 200 89

posted by  someone claiming to be kenton on  Sat Dec 1 13:49 CST 2001 [RELATED]

I've picked up a 5 bar oil pressure gauge from my local yard, but I can't seem to get the sender to come off of the block. I've even gone to other 240 turbos and the same issue with all of them. The local specialty yard wants $60 for it (if I can pull it myself it will be about $3, so any help is greatly appreciated!).







  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: how do you get the damn oil pressure sender off of the block? 200 89

posted by  someone claiming to be Chris Blunt on  Sat Dec 1 14:31 CST 2001 [RELATED]

Whatever tool you end up using, spray the heck out of the sender base with P'Blaster before you start. That stuff is amazing.







  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

17 mm. stubby 200 89

posted by  someone claiming to be Bill D on  Sat Dec 1 14:01 CST 2001 [RELATED]

They use 17mm hex on the base of the sender. I bought a stubby wrench at Sears for about $13.00 just for that job. It is not easy and you will break the adaptor off but you can then remove the sender. make sure to pull the wires off because one of the connectors is a real oddball anfd hard to match.

Bill D.






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.