I have a 1993 940 turbo wagon. Recently, the washer fluid stopped coming out of the pump on the front of the car, acting as if the reservoir was empty. (The rear washer continued to work with no problem.) I found that a hose which comes from the top of the reservoir was split on the end where it connected to the reservoir. When I pulled it off of the reservoir, the other end of the hose easily and inadvertently slipped from it's position. In attempting to replace the hose, I cannot find where the other end connects. It appears that it might be behind the turbo housing, but I'm not sure. Do I need to remove the turbo housing to get to this? Perhaps if I knew what I was looking for it would be easier to find :) Any help would be much appreciated.

Natman, Trace the hose from the hood (washer jets) back to the center of the firewall. Behind the corrugated plastic wiring cover you should see a plastic fitting that has a red top. Your hose will slip onto this fitting. You can sort of pull it out of the area that it is tucked into. Good luck!@ Chris