Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2009 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Thread Pitch for 240 Oil Drain Plug 200

Does anyone know the thread pitch for the 240 oil pan drain plug? Is it M16-1.5 thread or possibly M26-1.5?
Dave Barton
Lake Elsinore, CA








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Thread Pitch for 240 Oil Drain Plug 200

Hi Dave,
Always have enjoyed seeing the your car on your web site. To my knowledge the
oil drain plug is SAE 3/4 16. This is the same as the oil filter. The oil drain
plug screws right into the filter and I know the filter is 3/4 16.
Dave 82 242ti








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Thread Pitch for 240 Oil Drain Plug 200

I don't know Dave, I was told by a machine shop/ fastener supply that "it seems to be 3/4" std. thread". Don't remember exactly the std vs npt thread part but I remember the 3/4" part. My impression is that it never changed over the 240 run. Clay might know and when he was getting an oil temp sender his nearest metric one did not do it. Leaked.
Best is to pull a plug and have a shop really have a good look.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.