In my ongoing search for retractables, I've come across rear belts from a 960 on ebay for not a lot of money. As I've not had retractables, I don't really know what to look for as far as will they work/bolt in. The ebay item numbers are:
seat belt-1807239551; seat belt locks-1807239986. Sorry I don't have the URLs.

Does it seem reasonable that the belt mechanism could mount on the pilar, up high and the other, fixed end could mount low, and the latch could just replace the current latch between the seats?
Originally I thought the reverse, but noticed that there is a plastic rivet or somesuch on the belt to keep latch from sliding down the belt - if installation was inverted, (retractor on the floor and fixed point up high) the latch would always be down near the floor. Is this making sense?
I don't know if belt lengths would be different, as in these could be too short. They look like they should be long enough, but I don't know. Anybody out there tried this. It could be a simple, inexpensive upgrade, for all of us in pre-retractable cars! thanks

Don't 960's have tensioners in the belt hooked into the airbg sensors? People like Securon do an aftermarket retractable tha fits and is relatively cheap.

Regards


Pete

I've never even been inside a 960 but you need to be sure that you
get the things the belt latches into between the seats. They varied
a lot, so if you don't get the right one your seat belts will be unusable.

The belts from the later 140/164 will work with a little elbow grease.
--
George Downs Bartlesville, Oklahoma