Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2005 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine Cold Start Problem 200 1984

posted by  someone claiming to be Habib on  Wed Feb 27 03:15 CST 2002 [RELATED]

My 1984 DL, with engine B23F has problem starting early in the morning. The engine fires up but after couple of back fire stops immediately. The air mass meter has been replaced, the injectors are being serviced. The engine has good compression with no internal leak. When engine stalls, the spark plugs are becoming wet and black. I appreciate any tip!
Thank you, Habib








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Engine Cold Start Problem 200 1984

    posted by  john r. on  Wed Feb 27 09:41 CST 2002
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Tue Mar 9 09:41 CST 2010
    [RELATED]

    Check the ecu temperature sensor(2 wires on sensor, 1 wire is temp. gauge sender) located under the intake manifold runners 3 and 4. If the sensor or its wiring/connector is bad the ecu doesn't know what temperature the engine is and it instructs the injectors to deliver the wrong quantity of fuel.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.