Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2005 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

child's seat tether strap anchor bolt 700 1987

I need to install an anchor bolt for a tether strap in my newly purchased 87 740 GLE wagon. Has anyone done this job? What is the exact location where you drilled the hole? Anything I should watch out for? I'm thinking the car seat will go on in the middle or on the 60 side of the 40/60 split back seat.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    child's seat tether strap anchor bolt 700 1987

    Sorry to have no knowledge on the 700, but I just did this on the 850. Bone easy, and the three existing threaded holes are on the back of the seat corresponding with three passenger locations. Just pop out the plug install tie down with thick washer and Nylock patched bolt.

    My point is when I bought all three parts from the Volvo dealer for a total of $3.29, they had complete knowledge for my year and location. Call the dealer, it's the law for them to know this.
    --
    www.fidalgo.net/~brook4








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    child's seat tether strap anchor bolt 700 1987

    The seat should have come with instructions describing this.

    Check if they anchor points already exist (they are pre-installed in the Australian market)









<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.