Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2009 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Injector seals 200

posted by  Davewingman on  Sun Mar 10 03:37 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

List,
It appears I have a leaking injector seal.
After smelling gas while starting and driving I popped the hood
and noticed the number 3 injector was wet on the outside.
My questions are: 1. How do I disconnect the injector from the fuel rail.
2. What is a good source of o-rings for this? (ie. cheap)



Thanks,
Dave







  REPLY TO THIS MESSAGE    PRINT   SAVE 

Injector seals 200

posted by  Joe HC on  Sun Mar 10 05:02 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jun 21 08:19 CST 2008
[RELATED]

What kind of injector system do you have? I have the non-electric kind (I forgot the exact terminology), and replacing the seals on them was very easy. I got the seals from IPD for very cheap, you can call them. To remove them, I unbolted the plastic holder which attaches the injector to the engine and pulled them out. One must be careful since the "plastic arm" is real easy to break. Again, that was for my type of injector.

--Joe HC
--
1977 244, B21F engine, 140K, 'carlsbad yellow', IPD anti-sway bars, Minneapolis, MN







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.