Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2002 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replacing inner tierod 200 1985


Can anyone tell me the procedure to replace inner tierod?Its ZF rack and I ordered the parts today.Inner tierod,outer tierod and boot but can't find any imfo in Bentley.Thanks in advance,Charlie








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replacing inner tierod 200 1985

...and if you're a plumber, use a pipe wrench.

Rene
--
1988 745 GLE B230F M46. Toronto. 370000Km. Suspension upgraded and lowered (B23FT ready for installation). 1982 242 GLT project (B23ET LPT to be included) Also in charge of GF's 1986 244








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replacing inner tierod 200 1985

Only done CAM's but semi-similiar with ZF:

With the boot out of the way, you should see the bent over washerlike device - carefully bend this up and out of the way, then grip and wrench off....reverse on and bend tangs back into position....

Brief, but you'll see what I'm yapping about - pretty straight forward. Les Lyne did his last spring - I remember 'cause he called me.
--
http://www.fidalgo.net/~brook4/oilslubesfilters.html







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.